AFS RowGuide™

Frequently Asked Questions

• Why is the RowGuide on my Axial-Flow combine not working even though I am seeing voltage feedback on the display?

• First, ensure that voltages are being measured on the Diag > RowG tab and not in the graph tab. Check to ensure the RowGuide harness is connected to the correct connector. Most Axial-Flow combines have a 4-pin deutsch connector under the cab that will accept the RowGuide harness, however, this is not the appropriate connection for AFS RowGuide. Most Axial-Flow combines will have a separate harness coiled up by the NAV controller, under the RH console, beneath the cover which will need to be pushed through the grommet in the floor to be connected to the RowGuide harness.

• Does the Pro 700 save data to the internal memory of the display?

• The AFS Pro 700 display does not save all data to the internal memory. To save mapping data, a USB memory device must be installed in the display during operation. Examples of mapping data include: combine mapping (yield and moisture), as-applied mapping (seed, fertilizer, herbicide, etc.), vehicle data mapping (fuel used, engine load, slip, etc.). If operating without a USB, mapping data will be shown on the display, but when the display is shut down, it will not be saved. There is no way to recover this data.

• Is it possible to transfer my unlocks from my old display to new?

• Unlocks that can be transferred are:

  • Task Controller
  • AccuStat
  • RowGuide
  
  

  Unlocks can be transferred to and from the following displays:

  • Pro 600 to Pro 700
  • Pro 300 to Pro 700
  • Pro 700 to Pro 700
  
  

  Contact your local dealer for more details.